qileinflatable.nacy          qile@qileinflatable.com
Combos/ bouncy slide
Water Pool/Pool Park
Water Games/ Water Park
Bounce Houses / Jumps bouncy
Inflatable Slide/Dry Slide
water slide/wet slide with pool
Interactive Sports / Games
Inflatable Castle/ Castle slide
Fun City / Playground
Inflatable Tent/Dome
obstacle course/ inflatable obstacle
Inflatable Screen
Zorb Ball/bumper ball
Water Ball/Walking Ball
blimp/Balloon/with light
Air/ windy/Skydancer
Inflatable Arch/ Archway
inflatable Christmas /Halloween
Snow Globe
Inflatable Cartoon
hand boat
Inflatable boat
Inflatable Tunnel sports
Paint Ball
Mini Bouncy castle
PVC Models
Metal Frame Pool
inflatable paddle board
Carry me/Cartoon trousers
*How to maintain inflatable games
*How to Install and Setup of Inflatables
*How to repair inflatable games
*what is the material we used
*How to Buy a Bouncy Castle
*The effect of the inflatable shape
--Home >> Product Knowledge / Attaching the fan--

  • The fan should be attached to the inflation tube located at the rear of the bouncy castle or on the side of the bouncy castle (the Fun Run bouncy castle has an inflation tube on both sides).
  • Attach the fan to the small pipe at the rear of the unit. Ensure that the pipe is fully extended and firmly attached to the motor.
  • Ensure that the motor will not tip or move and that the intake opening is covered with screening.
  • A ttach the motor to the power source. You may now switch on. At first the motor will require about 30 amps, but will then after a short period of time the current draw will drop to approximately 7 amps.
  • The unit should inflate in about 2-3 minutes (maximum). If, after this time, it has not fully inflated, firstly check that you have tied off the larger pipe at the rear, secondly ensure that the electric cable is sufficient to carry the required current, and thirdly ensure that you have not in some way damaged the unit



Home / Instock / Product Knowledge / News / How to Pay / How to Order / recommend/ sitemap
Copyright:QILE Inflatable Co., Ltd.